Apply Vinyl Lettering Windex

Apply water to the back side of the.

Apply vinyl lettering windex.

Wipe away the excess windex and let the decals take a set. Get the best results when applying car window decals by following expert tips. The adhesive on the back of the vinyl lettering should stick well to your surface if it has been properly cleaned and prepped. If you have never applied vinyl die cut decals it is recommend to do a little research online.

If air bubbles occur puncture with a pin and smooth down. Use the squeegee to squeeze out all the windex and air bubbles from underneath the decal. Peel the backing paper from the decal. Mild detergents or solvents can be used to remove wax grease tar etc.

The vinyl will not stick as well to any oil or waxy surface. Glass cleaners such as windex can be used to remove dirt grit and water soluble substances. Only remove the wax paper when you are ready to apply the decal to prevent dirt from getting on the adhesive surface. This is key and it s a good time to walk away from the car.

How to apply vinyl lettering racing stripes vinyl stickers vinyl decals pinstripes and more. Apply rubbing alcohol to remove any remaining oils or waxes from the vehicle s surface. Use a little rubbing alcohol to clean the area where the decal will be applied. If you re applying the decal to glass do not use windex or other ammonia based cleaners.

Final note the application of this vinyl decal requires a degree of dexterity and concentration. To apply a vinyl cut decal prepare the metal as above and wash with soap and water including new paint. Remove the wax paper. There are many youtube videos and websites that have great tutorials on how to apply vinyl die cut decals.

Squeegee windex from under the decal beginning in the center and working outward. Surface should be clean and dry before applying vinyl lettering. Whether you are applying a small decal such as a college sticker or parking permit or adhering a large rear window graphic choosing the right tools in the best weather conditions and taking plenty of time will assure effective decal application. If there are larger areas with the adhesive we recommend spraying the area with windex and with a soft cloth that will not scratch the vinyl clean the area.

Do not use windex in an aerosol can. The ammonia interferes with the adhesive. Apply vinyl lettering to your surface lower the mask layer and using your squeegee press firmly at a 45 degree angle starting from the middle and going out. They are all a little different but very helpful.

Vinyl can be applied to any smooth surface. Peel off the wax paper using a friend to help with bigger decals.